Cisco Catalyst 4500 Series - Autoboot Process Output

6-37
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 6 Programmability
Sample Configuration and Reference Information
;HostName=TestHost
[00:ff:a4:0e:ef:99]
#This host has no IP
#This host will not get an IP, even from Dynamic Ranges
#You can use such entries to prevent a host from getting an IP from this Server.
Autoboot Process Output
Autoboot Process Output—Using HTTP, page 6-37
Autoboot Process Output—Using TFTP, page 6-40
Autoboot Process Output—Using HTTP
The following is sample output of the autoboot process on Catalyst 4500-X Series Switches. .
• The HTTP server from which the files are being downloaded is example-httpserver-url.com.
• The image, configuration, script, and ova files being downloaded are example-ios-image.bin,
example-config.config, example-script.py, and example_dmi_container.ova respectively.
rommon 1 >reset
Resetting .......
rommon 2 >
Rommon (G) Signature verification PASSED
Rommon (P) Signature verification PASSED
FPGA (P) Signature verification PASSED
************************************************************
* *
* Welcome to Rom Monitor for WS-C4500X-16 System. *
* Copyright (c) 2008-2014 by Cisco Systems, Inc. *
* All rights reserved. *
* *
************************************************************
Rom Monitor (P) Version 15.0(1r)SG14
CPU Rev: 2.2, Board Rev: 3, Board Type: 108
CPLD Mobat Rev: 2.0x4377.0xb277
Chassis: WS-C4500X-16
MAC Address : 30-e4-db-f8-a4-7f
Ip Address : Not set.
Netmask : Not set.
Gateway : Not set.
TftpServer : Not set.
Non-Redundant system or peer not running IOS
System Uplinks & Linecards have been reset!!
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . .
Management Ethernet Link Up: 1Gb Full Duplex