Cisco Catalyst 4500 Series Software Configuration Guide

61-12
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.8.0E and IOS 15.2(4)E
Chapter 61 DHCPv6 Options Support
Feature Information for DHCPv6 Options Support
Feature Information for DHCPv6 Options Support
The following table provides release information about the feature or features described in this module.
This table lists only the software release that introduced support for a given feature in a given software
release train. Unless noted otherwise, subsequent releases of that software release train also support that
feature.
Use Cisco Feature Navigator to find information about platform support and Cisco software image
support. To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is
not required.
Table 1 Feature Information for DHCPv6 Options Support
Feature Name Releases Feature Information
CAPWAP Access Controller DHCP
Option 52
Cisco IOS
Release 15.2(5)E2
The Control And Provisioning of Wireless Access
Points (CAPWAP) protocol allows Lightweight
Access Points to use DHCPv6 to discover a Wireless
Controller to which it can connect.
DHCPv6 Interface-ID Cisco IOS
Release 15.2(5)E2
The interface-ID option is used by relay agents to
decide which interface should be used when
forwarding a RELAY-REPLY packet.
DHCPv6 Relay Agent Cisco IOS
Release 15.2(5)E2
A DHCP relay agent, which may reside on the client’s
link, is used to relay messages between the client and
server.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E