Cisco Catalyst 4500 Series Software Configuration Guide

59-24
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 59 Configuring the Cisco IOS DHCP Server
Configuration Examples for the Cisco IOS DHCP Server
Clearing DHCP Server Variables
Configuration Examples for the Cisco IOS DHCP Server
• Example: Configuring a DHCP Database Agent or Disabling Conflict Logging, page 59-24
• Example: Excluding IP Addresses, page 59-24
• Example: Configuring a DHCP Address Pool, page 59-25
• Example: Configuring Manual Bindings, page 59-27
• Example: Configuring Static Mapping, page 59-28
• Example: Customizing DHCP Server Operation, page 59-29
• Example: Configuring a Remote Device to Import DHCP Server Options from a Central DHCP
Server, page 59-30
• Example: Configuring DHCP Address Allocation Using Option 82, page 59-31
• Example: Configuring a Static Route with the Next-Hop Dynamically Obtained Through DHCP,
page 59-32
Example: Configuring a DHCP Database Agent or Disabling Conflict Logging
The following example shows how to store bindings on host 172.16.4.253. The file transfer protocol is
FTP. The server waits for 2 minutes (120 seconds) before performing database changes.
Switch> enable
Switch# configure terminal
Switch(config)# ip dhcp database ftp://user:password@172.16.4.253/router-dhcp write-delay
120
Switch(config)# exit
Example: Excluding IP Addresses
In the following example, server A and server B service the subnet 10.0.20.0/24. If the subnet is split
equally between the two servers, server A is configured to allocate IP addresses 10.0.20.1 to 10.0.20.125
and server B is configured to allocate IP addresses 10.0.20.126 to 10.0.20.254.
Step 1
Switch> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
Switch# clear ip dhcp binding {address |
*}
Deletes an automatic address binding from the DHCP database.
• Specifying the address argument clears the automatic binding
for a specific (client) IP address, whereas specifying an
asterisk (*) clears all automatic bindings.
Step 3
Switch# clear ip dhcp conflict {address |
*}
Clears an address conflict from the DHCP database.
• Specifying the address argument clears the conflict for a
specific IP address, whereas specifying an asterisk (*) clears
conflicts for all addresses.
Step 4
Switch# clear ip dhcp server statistics
Resets all DHCP server counters to 0.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E