Cisco Catalyst 4500 Series Software Configuration Guide

61-8
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.8.0E and IOS 15.2(4)E
Chapter 61 DHCPv6 Options Support
How to Configure DHCPv6 Options Support
ADVERTISE 1
REPLY 1
Step 4 debug ipv6 dhcp-ldra all
Enables all LDRA debugging flows. The fields in the example below are self-explanatory.
Example:
Device# debug ipv6 dhcp-ldra all
05:44:10: DHCPv6 LDRA API: Entered ipv6_dhcp_ldra_post_processor.
05:44:10: DHCPv6 LDRA EVENT: [Gi1/0/3 Vlan 5] Received SOLICIT from 2001:DB8:1::1 to
FF02::1:2.
05:44:10:
05:44:10:
05:44:10:
05:44:10:
05:44:10: 000300010015F906981B
05:44:10: option ORO(6), len 4
05:44:10: DNS-SERVERS,DOMAIN-LIST
05:44:10: option IA-NA(3), len 12
05:44:10: IAID 0x00040001, T1 0, T2 0
05:44:10: DHCPv6 LDRA API: Entered dhcpv6_ldra_client_facing_new_pak.
05:44:10: DHCPv6 LDRA EVENT: [Vlan 5] Sending RELAY-FORWARD from 2001:DB8:1::1
to FF02::1:2.
!
!
!
Configuring CAPWAP Access Points
Command or Action Purpose
Step 1
Device> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
Device# configure terminal
Enters global configuration mode.
Step 3
Device(config)# ipv6 dhcp pool poolname
Configures a DHCPv6 server configuration information pool and
enters DHCPv6 pool configuration mode.
Step 4
Device(config-dhcpv6)# capwap-ac
address ipv6-address
Configures CAPWAP access controller address.
Step 5
Device(config-dhcpv6)# end
Exits DHCPv6 pool mode and returns to privileged EXEC mode.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E