Cisco Catalyst 4500 Series - First-Hop Security

63-4
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 63 Support for IPv6
About IPv6
First-Hop Security
The following First-Hop Security (FHS) features are supported for IPv6 on the Catalyst 4500-E and -X
series switch:
• IPv6 RA Guard
• IPv6 Source Guard and Prefix Guard
• IPv6 Snooping
• DHCPv6 Guard
• IPv6 Neighbor Discovery Multicast Suppress
• IPv6 Destination Guard
• IPv6 RFCs
You can find information about these features at this location:
IPv6 First-Hop Security Configuration Guide, Cisco IOS Release 15E
IPv6 First-Hop Security Configuration Guide, Cisco IOS Release XE 3E
QoS
The following QoS features are supported for IPv6 on the Catalyst 4500 series switch:
• MQC packet classification
• MQC traffic shaping
• MQC traffic policing
• MQC packing marking and remarking
• Queueing
You can find information about these features at this location:
QoS: Classification Configuration Guide, Cisco IOS XE Release 3S
Management
The following management features are supported for IPv6 on the Catalyst 4500 series switch:
• Ping
• Syslog
• Netconf support
• SNMP
• SOAP
• HTTP(s)
You can find information about these features at this location:
Network Management Configuration Guide Library, Cisco IOS Release 15E
Network Management Configuration Guide Library, Cisco IOS XE Release 3E