Cisco Catalyst 4500 Series Software Configuration Guide

35-19
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 35 Configuring Layer 3 Interfaces
Configuring EIGRP Stub Routing
Configuring EIGRP Stub Routing
To configure a remote or spoke router for EIGRP stub routing, perform this task:
Verifying EIGRP Stub Routing
To verify that a remote router has been configured as a stub router with EIGRP, use the
show ip eigrp neighbor detail command from the distribution router in privileged EXEC mode. The last
line of the output shows the stub status of the remote or spoke router. The following example shows
output is from the show ip eigrp neighbor detail command:
Switch# show ip eigrp neighbor detail
IP-EIGRP neighbors for process 1
H Address Interface Hold Uptime SRTT RTO Q Seq Type
(sec) (ms) Cnt Num
0 10.1.1.2 Se3/1 11 00:00:59 1 4500 0 7
Version 12.1/1.2, Retrans: 2, Retries: 0
Stub Peer Advertising ( CONNECTED SUMMARY ) Routes
Monitoring and Maintaining EIGRP
To delete neighbors from the neighbor table, use the following command:
Command Purpose
Step 1
Switch(config)# router eigrp 1
Configures a remote or distribution router to run
an EIGRP process.
Step 2
Switch(config-router)# network network-number
Specifies the network address of the EIGRP
distribution router.
Step 3
Switch(config-router)# eigrp stub [receive-only |
connected | static | summary | redistributed]
Configures a remote router as an EIGRP stub
router.
The receive-only keyword sets the router as a
receive-only neighbor.
The connected keyword advertises connected
routes.
The static keyword advertises static routes.
The summary keyword advertises summary
routes.
The redistributed keyword enables you to send
routes that have been redistributed from other
dynamic routing protocols.
Note It is still necessary to redistribute the
routes from the other routing processes
with the redistribute command.
Command Purpose
Switch# clear ip eigrp neighbors [ip-address |
interface]
Deletes neighbors from the neighbor table.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E