Cisco Catalyst 4500 Series Software Configuration Guide

77-11
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 77 Configuring Call Home
Configuring Call Home
This example shows how to manually send a Call Home test message:
Switch# call-home test “test of the day” profile Ciscotac1
Sending a Call Home Alert Group Message Manually
To manually trigger a Call Home alert group message, perform this task:
When manually sending Call Home alert group messages, note the following guidelines:
• You can only manually send the configuration, diagnostic, and inventory alert groups.
• When you manually trigger a configuration, diagnostic, or inventory alert group message and you
specify a destination profile name, a message is sent to the destination profile regardless of the
profile’s active status, subscription status, or severity setting.
• When you manually trigger a configuration or inventory alert group message and do not specify a
destination profile name, a message is sent to all active profiles that have either a normal or periodic
subscription to the specified alert group.
• When you manually trigger a diagnostic alert group message and do not specify a destination profile
name, the command will cause the following actions:
– For any active profile that subscribes to diagnostic events with a severity level of less than
minor, a message is sent regardless of whether the module or interface has observed a diagnostic
event.
– For any active profile that subscribes to diagnostic events with a severity level of minor or
higher, a message is sent only if the specified module or interface has observed a diagnostic
event of at least the subscribed severity level; otherwise, no diagnostic message is sent to the
destination profile.
This example shows how to send the configuration alert-group message to the destination profile:
Switch# call-home send alert-group configuration
This example shows how to send the diagnostic alert-group message to the destination profile for a
specific module, slot/subslot, or slot/bay number.
Switch# call-home send alert-group diagnostic module 3 5/2
This example shows how to send the diagnostic alert-group message to all destination profiles for a
specific module, slot/subslot, or slot/bay number.
Switch# call-home send alert-group diagnostic module 3 5/2 profile Ciscotac1
Command Purpose
Step 1
Switch# call-home send alert-group
configuration [profile name]
Sends a configuration alert group message to one
destination profile if specified, or to all subscribed
destination profiles.
Switch# call-home send alert-group
diagnostic {module number | slot/subslot
| slot/bay} [profile name]
Sends a diagnostic alert group message to the
configured destination profile if specified, or to all
subscribed destination profiles. You must specify the
module or port whose diagnostic information should
be sent.
Switch# call-home send alert-group
inventory [profile name]
Sends an inventory alert group message to one
destination profile if specified, or to all subscribed
destination profiles.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E