CHAPTER
82-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
82
Configuring MIB Support
This chapter describes how to configure SNMP and MIB support for the Cisco 4500 series switch. It
includes the following sections:
• Determining MIB Support for Cisco IOS Releases, page 82-1
• Using Cisco IOS MIB Tools, page 82-1
• Downloading and Compiling MIBs, page 82-2
• Enabling SNMP Support, page 82-4
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
Determining MIB Support for Cisco IOS Releases
To determine which MIBs are included in the Cisco IOS release running on the Cisco 4500 series switch,
follow these steps:
Step 1 Go to the Cisco MIBs Support page:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Step 2 Under Cisco Access Products, select a Cisco 4500 switch to display a list of MIBs supported on the
Cisco 4500 switches.
Step 3 Scroll through the list to find the release you are interested in.
Using Cisco IOS MIB Tools
This section describes how to access the Cisco MIB tools page. The MIB Locator finds MIBs in
Cisco IOS software releases. You can find general MIB information, instructions about how to use the
SNMP Object Navigator which translates SNMP object identifiers (OIDs) into SNMP names, and how
to load Cisco MIBs.
To Next Page
Loading...
Need help?
General
