EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1443 background imageLoading...
Page #1443 background image
CHAPTER
53-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
53
Configuring Wired Guest Access
This chapter describes the tasks for configuring wired guest access on a Catalyst 4500 series switch and
includes these major sections:
• Wired Guest Access, page 53-1
• Information about Wired Guest Access, page 53-2
• How to Configure Wired Guest Access, page 53-4
• Configuration Examples for Wired Guest Access, page 53-6
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
Note To identify the hardware platform or software image information associated with a feature, use the
Feature Navigator on Cisco.com to search for information about the feature or refer to the software
release notes for a specific release.
Wired Guest Access
The Wired Guest Access feature enables guest users of an enterprise network that supports both wired
and wireless access to connect to the guest access network from a wired Ethernet connection. The wired
Ethernet connection is designated and configured for guest access. Wired session guests on mobility
agents are directed to a wireless guest controller in a demilitarized zone (DMZ) through a Control And
Provisioning of Wireless Access Points (CAPWAP) tunnel.
Wired guest access can be configured in a dual-controller configuration that uses both an anchor
controller and a foreign controller. A dual-controller configuration isolates wired guest access traffic.
Restrictions for Wired Guest Access
• Wired guest access does not work on Supervisor Engine 8-E, in multiple-host mode or in multi-
authentication mode.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals