Cisco Catalyst 4500 Series Software Configuration Guide

61-10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.8.0E and IOS 15.2(4)E
Chapter 61 DHCPv6 Options Support
Additional References for DHCPv6 Options Support
Example: Configuring CAPWAP Access Points
Device> enable
Device# configure terminal
Device(config)# ipv6 dhcp pool pool1
Device(config-dhcpv6)# capwap-ac address 2001:DB8::1
Device(config-dhcpv6)# end
Device#
Additional References for DHCPv6 Options Support
Related Documents
Standards and RFCs
MIBs
Related Topic Document Titl1
Cisco IOS commands Cisco IOS Master Commands List, All Releases
Catalyst 4500 commands Cisco IOS Command Reference Guides for the Catalyst 4500 Series
Switch
Standard/RFC Title
RFC 3315 Dynamic Host Configuration Protocol for IPv6
RFC 4649 Dynamic Host Configuration Protocol for IPv6 (DHCPv6) Relay
Agent Remote-ID Option
RFC 5417 Control And Provisioning of Wireless Access Points (CAPWAP)
Access Controller DHCP Option
RFC 6221 Lightweight DHCPv6 Relay Agent
MIB MIBs Link
• To locate and download MIBs for selected platforms, Cisco software
releases, and feature sets, use Cisco MIB Locator found at the
following URL:
http://www.cisco.com/go/mibs

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E