Cisco Catalyst 4500 Series Software Configuration Guide

72-9
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 72 Configuring SNMP
Configuring SNMP
Note You cannot use the snmp-server enable informs command. To enable the sending of SNMP inform
notifications, use the snmp-server enable traps command combined with the snmp-server host
host-addr informs command.
This example shows how to assign the string comaccess to SNMP, to allow read-only access, and to
specify that IP access list 4 can use the community string to gain access to the switch SNMP agent:
Switch(config)# snmp-server community comaccess ro 4
Configuring SNMP Groups and Users
You can specify an identification name (engine ID) for the local or remote SNMP server engine on the
switch. You can configure an SNMP server group that maps SNMP users to SNMP views, and you can
add new users to the SNMP group.
To configure SNMP on the switch, perform this task:
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# snmp-server engineID
{local engineid-string | remote
ip-address
[udp-port port-number]
engineid-string}
Configures a name for either the local or remote copy of SNMP.
• The engineid-string is a 24-character ID string with the name of
the copy of SNMP. You need not specify the entire 24-character
engine ID if it has trailing zeros. Specify only the portion of the
engine ID up to the point where only zeros remain in the value.
For example, to configure an engine ID of
123400000000000000000000, you can enter this:
snmp-server engineID local 1234
• If you select remote, specify the ip-address of the device that
contains the remote copy of SNMP and the optional UDP port on
the remote device. The default is 162.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E