Cisco Catalyst 4500 Series - Command-Line Interfaces

CHAPTER
2-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
2
Command-Line Interfaces
This chapter describes the CLIs you use to configure the Catalyst 4500 series switch. This chapter
includes the following major sections:
• Accessing the Switch CLI, page 2-2
• Performing Command-Line Processing, page 2-3
• Performing History Substitution, page 2-4
• About Cisco IOS Command Modes, page 2-4
• Getting a List of Commands and Syntax, page 2-5
• ROMMON Command-Line Interface, page 2-7
• Archiving Crashfiles Information, page 2-8
• Displaying a Crash Dump for Supervisor Engine 6-E and 6L-E, page 2-8
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference, you can locate it in
the Cisco IOS library. See related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
The following command changes apply only to Supervisor Engines 6-E and 6L-E:
• The rename command is supported in the FAT file system for bootflash and slot0.
• The fsck command is supported for the slot0 device. It is not supported in the file systems on
supervisor engines other than Supervisor Engine 6-E and 6L-E.
The following additional file management commands are supported on Supervisor Engine 7-E,
Supervisor Engine 7L-E, and Supervisor Engine 8-E:
• verify <filename>
• delete <filename>
• copy <source_flename>, target_filename>