Cisco Catalyst 4500 Series Software Configuration Guide

63-3
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 63 Support for IPv6
About IPv6
• AAAA DNS lookups over an IPv4 transport
You can find information about these features at this location:
IPv6 Addressing and Basic Connectivity Configuration Guide, Cisco IOS Release 15E
IPv6 Addressing and Basic Connectivity Configuration Guide, Cisco IOS Release XE 3E
DHCP
The following DHCP features are supported for IPv6 on the Catalyst 4500 series switch:
• Relay agent
• Relay agent notification for prefix delegation
• Reload persistent interface ID option
• Ethernet remote ID option
• Stateless auto-configuration
You can find information about these features at this location:
IP Addressing: DHCP Configuration Guide, Cisco IOS Release 15E
IP Addressing: DHCP Configuration Guide, Cisco IOS XE Release 3E
Security
The following security features are supported for IPv6 on the Catalyst 4500 series switch:
• Secure Shell (SSH) support over IPv6
• Traffic filters
• standard access control lists (ACL)
• extended access control lists
• ACL accounting
• ACL addressing
• ACL DSCP
• ACL flags
• ACL flows
• ACL fragments
• ACL ICMP codes
• ACL logging
• ACL protocols
You can find information about these features at this location:
Security Configuration Guide: Access Control Lists, Cisco IOS Release 15E
Security Configuration Guide: Access Control Lists, Cisco IOS XE Release 3E

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E