40-28
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 40 Configuring Bidirection Forwarding Detection
Additional References
Note The static route on SwitchB exists solely to enable the BFD session between 10.201.201.1 and
10.201.201.2. If there is no useful static route to configure, select a prefix that will not affect packet
forwarding, for example, the address of a locally configured loopback interface.
Additional References
Related Documents
Standards
Related Topic Document Title
Cisco IOS commands Cisco IOS Master Commands List, All Releases
Configuring and monitoring BGP Cisco BGP Overview” module of the Cisco IOS IP Routing Protocols
Configuration Guide
Configuring and monitoring EIGRP “Configuring EIGRP” module of the Cisco IOS IP Routing Protocols
Configuration Guide
Configuring and monitoring OSPF “Configuring OSPF” module of the Cisco IOS IP Routing Protocols
Configuration Guide
BFD commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
Cisco IOS IP Routing: Protocol-Independent Command Reference
BGP commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
Cisco IOS IP Routing: Protocol-Independent Command Reference
EIGRP commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
Cisco IOS IP Routing: Protocol-Independent Command Reference
OSPF commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
Cisco IOS IP Routing: Protocol-Independent Command Reference
Standard Title
IETF Draft BFD for IPv4 and IPv6 (Single Hop), February 2009
IETF Draft Bidirectional Forwarding Detection, February 2009
To Next Page
Loading...
Need help?
General
