Cisco Catalyst 4500 Series Software Configuration Guide

32-4
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 32 Configuring LLDP, LLDP-MED, and Location Service
Configuring LLDP and LLDP-MED, and Location Service
• Slot, port, and port-type
• Client’s MAC address
• Client’s IP address
• 802.1X username if applicable
• Device category is specified as a wired station
• State is specified as Connected
• Serial number, UDI
• Model number
• Software version
• VLAN ID and VLAN name
Depending on the device capabilities, the switch obtains this client information at link down:
• Slot and port that was disconnected
• Client’s MAC address
• Client’s IP address
• 802.1X username if applicable
• Device category is specified as a wired station
• State is specified as Disconnected
• Serial number, UDI
• Model number
• Software version
• VLAN ID and VLAN name
If an administrator changes a location address at the switch, the information is reported to the MSE. The
switch sends a NMSP location notification message that identifies the list of ports affected by the change
and the changed address information.
Configuring LLDP and LLDP-MED, and Location Service
This section contains this configuration information:
• Default LLDP Configuration, page 32-5
• Configuring LLDP Characteristics, page 32-5
• Disabling and Enabling LLDP Globally, page 32-6
• Disabling and Enabling LLDP on an Interface, page 32-7
• Configuring LLDP-MED TLVs, page 32-9
• Configuring Network-Policy Profile, page 32-10
• Configuring LLDP Power Negotiation, page 32-11
• Configuring Location TLV and Location Service, page 32-12
• Monitoring and Maintaining LLDP, LLDP-MED, and Location Service, page 32-14

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E