Cisco Catalyst 4500 Series - Configuring a Switch to Receive MAC Address-Table Move Updates

24-11
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 24 Configuring Flex Links and MAC Address-Table Move Update
Configuring MAC Address-Table Move Update
Switch-ID : 01d0.2bfc.3180
Dst mac-address : 0180.c200.0010
Vlans/Macs supported : 4096/55000
Default/Current settings: Rcv Off/Off, Xmt Off/On
Max packets per min : Rcv 100, Xmt 120
Rcv packet count : 0
Rcv conforming packet count : 0
Rcv invalid packet count : 0
Rcv packet count this min : 0
Rcv threshold exceed count : 0
Rcv last sequence# this min : 0
Rcv last interface : None
Rcv last src-mac-address : 0000.0000.0000
Rcv last switch-ID : 0000.0000.0000
Xmt packet count : 0
Xmt packet count this min : 0
Xmt threshold exceed count : 0
Xmt pak buf unavail cnt : 0
Xmt last interface : fa1/2
Configuring a Switch to Receive MAC Address-Table Move Updates
To configure a switch to receive and process MAC address-table move update messages, perform this
task:
To disable the MAC address-table move update feature on the access switch, enter the
no mac address-table move update receive configuration command. To display the MAC address-table
move update information, enter the show mac address-table move update command.
This example shows how to configure a switch to receive and process MAC address-table move update
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(conf)# mac address-table move update
receive
Enables the switch to receive and process the MAC
address-table move updates.
Step 3
Switch(conf)# end
Returns to privileged EXEC mode.
Step 4
Switch# show mac address-table move update
Verifies the configuration.
Step 5
Switch# copy running-config startup config
(Optional) Saves your entries in the switch startup
configuration file.