Cisco Catalyst 4500 Series Software Configuration Guide

CHAPTER
40-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
40
Configuring Bidirection Forwarding Detection
Note Starting with Cisco IOS Release IOS 15.1(1)SG, Bidirectional Forwarding Detection (BFD) support was
introduced on Supervisor Engine 6-E, Supervisor Engine 6L-E, Catalyst 4900M, Catalyst 4948E, and
Catalyst 4948E-F Ethernet switches. With Cisco IOS XE 3.5.0E and IOS 15.2(1)E, supported was
extended to Supervisor Engine 7-E, and Supervisor Engine 7L-E. With Cisco IOS XE 3.6.0E and IOS
15.2(2)E, supported was extended to Supervisor Engine 8-E.
This document describes how to enable the BFD protocol, which is a detection protocol designed to
provide fast forwarding path failure detection times for all media types, encapsulations, topologies, and
routing protocols.
BFD provides a consistent failure detection method for network administrators in addition to fast
forwarding path failure detection. Because the network administrator can use BFD to detect forwarding
path failures at a uniform rate, rather than the variable rates for different routing protocol hello
mechanisms, network profiling and planning are simplified, and reconvergence time is more consistent
and predictable.
Note For details on all the BFD commands introduced in this chapter, see the URL:
http://www.cisco.com/en/US/docs/ios/iproute_pi/command/reference/iri_book.html
For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release. To find information
about the features documented in this module, and to see a list of the releases in which each feature is
supported, see the “Technical Assistance” section on page 40-29.
Use Cisco Feature Navigator to find information about platform support and Cisco software image
support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on
Cisco.com is not required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E