Cisco Catalyst 4500 Series Software Configuration Guide

55-14
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 55 Configuring Port Security
Configuring Port Security on PVLAN Ports
The following example shows how to configure rate limit for invalid source packets on Fast Ethernet
interface 5/1:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 5/1
Switch(config-if)# switchport port-security limit rate invalid-source-mac none
Switch(config-if)# end
Switch#
Example 8: Clearing Dynamic Secure MAC Addresses
The following example shows how to clear a dynamic secure MAC address:
Switch# clear port-security dynamic address 0000.0001.0001
The following example shows how to clear all dynamic secure MAC addresses on Fast Ethernet interface
2/1:
Switch# clear port-security dynamic interface fa2/1
The following example shows how to clear all dynamic secure MAC addresses in the system:
Switch# clear port-security dynamic
Configuring Port Security on PVLAN Ports
You can configure port security on a private VLAN port to take advantage of private VLAN functionality
as well as to limit the number of MAC addresses.
Note This section follows the same configuration model that was presented for access ports.
These sections describe how to configure trunk port security on host and promiscuous ports:
• Configuring Port Security on an Isolated Private VLAN Host Port, page 55-14
• Example of Port Security on an Isolated Private VLAN Host Port, page 55-16
• Configuring Port Security on a Private VLAN Promiscuous Port, page 55-16
• Example of Port Security on a Private VLAN Promiscuous Port, page 55-17
Configuring Port Security on an Isolated Private VLAN Host Port
Figure 55-1 illustrates a typical topology for port security implemented on private VLAN host ports. In
this topology, the PC connected through port a on the switch can communicate only with the router
connected using the promiscuous port on the switch. The PC connected through port a cannot
communicate with the PC connected through port b.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E