Cisco Catalyst 4500 Series Software Configuration Guide

75-49
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 75 Configuring Ethernet OAM and CFM
Displaying Ethernet OAM Protocol Information
Displaying Ethernet OAM Protocol Information
To display Ethernet OAM protocol information, you can use the privileged EXEC commands in
Table 75-4.
These examples show how to apply these commands:
Switch# show ethernet oam discovery
GigabitEthernet1/1
Local client
------------
Administrative configurations:
Mode: active
Unidirection: not supported
Link monitor: supported (on)
Remote loopback: supported
MIB retrieval: not supported
Mtu size: 1500
Operational status:
Port status: operational
Loopback status: no loopback
PDU revision: 10
Remote client
-------------
MAC address: 000f.8f03.3591
Vendor(oui): 00000C(cisco)
Administrative configurations:
PDU revision: 2
Mode: active
Unidirection: not supported
Link monitor: supported
Remote loopback: supported
MIB retrieval: not supported
Mtu size: 1500
Switch# show ethernet oam statistics
GigabitEthernet1/1
Counters:
---------
Information OAMPDU Tx : 101163
Information OAMPDU Rx : 51296
Unique Event Notification OAMPDU Tx : 0
Table 75-4 Displaying Ethernet OAM Protocol Information
Command Purpose
show ethernet oam discovery [interface
interface-id
]
Displays discovery information for all Ethernet OAM interfaces or
the specified interface.
show ethernet oam statistics [interface
interface-id
]
Displays detailed information about Ethernet OAM packets.
show ethernet oam status [interface
interface-id
]
Displays Ethernet OAM configuration for all interfaces or the
specified interface.
show ethernet oam summary
Displays active Ethernet OAM sessions on the switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E