EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1514 background imageLoading...
Page #1514 background image
57-10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 57 Configuring Control Plane Policing and Layer 2 Control Packet QoS
Monitoring CoPP
System-defined class maps(used by system-cpp-wireless-policy) cannot be used in policy maps for
regular QoS.
“regular QoS?”
The policy map named system-cpp-wireless-policy is dedicated for wireless CoPP.
We do not recommend any modification of system-cpp-wireless-policy other than specifying police
actions against various classes in it. Do not add user-defined class maps to this policy map.
Monitoring CoPP
You can enter the show policy-map control-plane command to develop site-specific policies, to monitor
statistics for the control plane policy, and to troubleshoot CoPP. This command displays dynamic
information about the actual policy applied, including rate information and the number of bytes (and
packets) that conformed or exceeded the configured policies both in hardware and in software.
The output of the show policy-map control-plane command is similar to the following:
Switch# show policy-map control-plane
Control Plane
Service-policy input: system-cpp-policy
Class-map: system-cpp-dot1x (match-all)
0 packets
Match: access-group name system-cpp-dot1x
Class-map: system-cpp-bpdu-range (match-all)
0 packets
Match: access-group name system-cpp-bpdu-range
* Class-map: system-cpp-cdp (match-all)
160 packets
Match: access-group name system-cpp-cdp
** police: Per-interface
Conform: 22960 bytes Exceed: 0 bytes
*
Class-map: system-cpp-sstp (match-all)
0 packets
Match: access-group name system-cpp-sstp
Class-map: system-cpp-cgmp (match-all)
0 packets
Match: access-group name system-cpp-cgmp
Class-map: system-cpp-hsrpv2 (match-all)
0 packets
Match: access-group name system-cpp-hsrpv2
Class-map: system-cpp-ospf (match-all)
0 packets
Match: access-group name system-cpp-ospf
Class-map: system-cpp-igmp (match-all)
0 packets
Match: access-group name system-cpp-igmp
Class-map: system-cpp-pim (match-all)
0 packets

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals