EasyManua.ls Logo

Cisco Catalyst 4500 Series - Network Assistant CLI Commands

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16-3
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 16 Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant
Network Assistant CLI Commands
Network Assistant CLI Commands
Table 16-2 describes the Network Assistant-related CLI commands.
Table 16-1 Network Assistant-Related Configuration on a Catalyst 4500 Series Switch
Parameters Default Value Recommended Value
Authentication Disabled Optional
IP address Depends on
community or
discovery option
1
1. You need to set an IP address in each switch for community device discovery and for the cluster
commander.
User selectable
IP HTTP port number 80 Optional
2
2. Port number on the Network Assistant and the Catalyst 4500 series switch must match.
IP HTTPS port number 443 Optional
3
3. You can only change this value for a cluster of devices. Port number on the Network Assistant and on the
Catalyst 4500 series switch must match. Value can be changed to any non-default number above 1024.
IP HTTP server Disabled Enabled
4
4. Required for Network Assistant to access the device.
Cluster run Disabled Enabled
5
5. Enabled only if you want to manage a cluster of devices.
Table 16-2 CLI Commands
Command Functions
[no] cluster enable
Names the cluster.
[no] cluster run
Enables clustering.
Note This command is used strictly for
clustering.
[no] ip http server
Configures the HTTP on a switch.
[no] ip http port port_number
Configures the HTTP port.
[no] ip domain-name domain_name
Configures the domain on the switch.
[no] ip http secure-server
Configures and enable HTTPS on a switch.
[no] ip http secure-port
port_number
Configures the HTTPS port.
[no] ip http max-connections
connection_number
Configures the maximum concurrent
connections to the HTTP server.
[no] ip http timeout-policy
idle idle_time life life_time
requests requests
Configures the HTTPS port.
A idle value of 180 seconds is recommended.
A life value of 180 seconds is recommended.
The recommended maximum number of
requests allowed is 25.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Related product manuals