EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #449 background imageLoading...
Page #449 background image
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
Chapter 9 Configuring Interfaces
Using the Ethernet Management Port
TFTP
If you want to use Fa1 port for TFTP operation, configure the Fa1 port as the source interface for TFTP as follows:
Switch(config)# ip tftp source-interface fastEthernet1
FTP
If you want to use an Fa1 port for an FTP operation, configure the Fa1 port as the source interface for FTP as follows:
Switch(config)# ip ftp source-interface fastEthernet1
SSH
If you want initiate SSH from your switch through the Fa1 port, enter the following command:
Switch# ssh –l login name -vrf mgmtVrf ip address
For example:
Switch# ssh –l xyz -vrf mgmtVrf 20.20.20.1
SSO Model
On a redundant chassis, management port behavior differs from that of a standard Ethernet port in that each supervisor engine
possesses a management port, and only the port on the active supervisor engine is enabled. The management port on the standby
supervisor engine is always disabled; it cannot switch any kind of traffic.
When a switchover occurs, the management port of the standby supervisor engine (now, active) is enabled and can be used to
switch traffic, while the management port on the “old” active supervisor engine is disabled.
Note The Cisco IOS configuration for the management port is synchronized between the two supervisor
engines. Under Cisco IOS, they possess the same IP address. To avoid address overlapping during a
switchover on a redundant chassis, you should assign a different IP address on the management port from
the one you assigned to the same port in the ROMMON configuration.
ISSU Model
In SSO mode, the running configurations on the active and standby supervisor engines must match. You cannot enable the
management port on a redundant chassis if one of the two supervisor engines is running an Cisco IOS image prior to Cisco IOS
Release 12.2(50)SG (wherein a management port is not supported).
When you perform an ISSU upgrade or downgrade between Cisco IOS Release 12.2(50)SG and a software image prior to Cisco
IOS Release 12.2(50)SG, we automatically disable the management port. The port configuration is restored when both software
images running on the supervisor engines are at least Cisco IOS Release 12.2(50)SG. A warning message is also displayed.
Supported Features on the Ethernet Management Port
The Ethernet management port supports these features:
Express setup
Network Assistant
Telnet with passwords

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals