EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #839 background imageLoading...
Page #839 background image
28-15
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 28 Configuring IGMP Snooping and Filtering, and MVR
Displaying IGMP Snooping Information
• Displaying MAC Address Multicast Entries, page 28-18
• Displaying IGMP Snooping Information on a VLAN Interface, page 28-18
• Configuring IGMP Filtering, page 28-30
Displaying Querier Information
To display querier information, perform this task:
This example shows how to display the IGMP snooping querier information for all VLANs on the
switch:
Switch# show ip igmp snooping querier
Vlan IP Address IGMP Version Port
---------------------------------------------------
2 10.10.10.1 v2 Router
3 172.20.50.22 v3 Fa3/15
This example shows how to display the IGMP snooping querier information for VLAN 3:
Switch# show ip igmp snooping querier vlan 3
Vlan IP Address IGMP Version Port
---------------------------------------------------
3 172.20.50.22 v3 Fa3/15
Displaying IGMP Host Membership Information
Note By default, EHT maintains a maximum of 1000 entries in the EHT database. Once this limit is reached,
no additional entries are created. To create additional entries, clear the database with the
clear ip igmp snooping membership vlan command.
To display host membership information, perform this task:
This example shows how to display host membership information for VLAN 20 and to delete the EHT
database:
Switch# show ip igmp snooping membership vlan 20
#channels: 5
#hosts : 1
Source/Group Interface Reporter Uptime Last-Join Last-Leave
Command Purpose
Switch# show ip igmp snooping querier [vlan
vlan_ID]
Displays multicast router interfaces.
Command Purpose
Switch# show ip igmp snooping membership
[interface interface_num][vlan vlan_ID]
[reporter a.b.c.d] [source a.b.c.d group
a.b.c.d]
Displays EHT information.
Note This command is valid only if EHT is
enabled on the switch.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals