Cisco Catalyst 4500 Series - Feature Information for ERSPAN

67-9
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 67 Configuring ERSPAN
Feature Information for ERSPAN
Feature Information for ERSPAN
Use Cisco Feature Navigator to find information about platform support and software image support.
Cisco Feature Navigator enables you to determine which software images support a specific software
release, feature set, or platform. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn.
An account on Cisco.com is not required.
Note Table 1 lists only the software release that introduced support for a given feature in a given software
release train. Unless noted otherwise, subsequent releases of that software release train also support that
feature.
Table 1 Feature Information for ERSPAN
Feature Name Releases Feature Information
ERSPAN Cisco IOS Release
15.2(4)E1
This module describes how to configure Encapsulated
Remote Switched Port Analyzer (ERSPAN). The Cisco
ERSPAN feature allows you to monitor traffic on ports or
VLANs and send the monitored traffic to destination
ports over a generic routing encapsulation (GRE) tunnel in
any VRF.
The following commands were introduced or modified:
destination (ERSPAN), erspan, filter (ERSPAN), and
show capability feature monitor.