Cisco Catalyst 4500 Series Software Configuration Guide

62-48
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 62 Configuring Network Security with ACLs
Configuring Object Group ACLs
Configuring an IPv6 OG ACL
Applying an IPv6 OG ACL to an Interface
Command or Action Purpose
Step 1
configure terminal
Example:
Switch# configure terminal
Enters global configuration mode.
Step 2
ipv6 access-list access-list-name
Example:
Switch(config)# ipv6 access-list
example-ipv6-acl
Defines an OG ACL with the specified name and enters
IPv6-ACL configuration mode.
Step 3
{deny | permit } { any | proto | object-group
service-object-group-name} { host ipv6-addr |
ipv6-prefix | ipv6-addr ipv6-wildcard-bits |
object-group source-network-object-group-name} {
host ipv6-addr | ipv6-prefix | ipv6-addr
ipv6-wildcard-bits | object-group
dest-network-object-group-name}
Example:
Switch(config-ext-nacl)# permit object-group
mySG object-group myOG any sequence 10
(Optional) Permits any packet that matches all conditions
specified in the statement.
In this example, the service object group my SG, allows
network object groups from myOG with any destination.
Step 4
Repeat the steps to specify the fields and values on
which you want to base your access list.
Remember that all sources not specifically permitted are
denied by an implicit deny statement at the end of the
access list.
Step 5
{end } | { exit }
Example:
Switch(config-v6service-group)# end
To exit the configuration mode, enter the end command.
To exit the IPv6-address object-group configuration mode,
enter the exit command.
Command or Action Purpose
Step 1
configure terminal
Example:
Switch# configure terminal
Enters the global configuration mode.
Step 2
interface type / slot
Example:
Switch(config)# interface vlan 100
Specifies the interface and enters interface configuration
mode.
The interface-type must be a Layer 3 interface.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E