80-13
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 80 Performing Diagnostics
Detailed Status
---------------
. = Pass U = Unknown
L = Loopback failure S = Stub failure
P = Port failure
E = SEEPROM failure G = GBIC integrity check failure
Ports 1 2 3 4 5 6
. . . . . .
___________________________________________________________________________
Switch#
Power-On Self-Test Results
The following topics are discussed:
• Sample Display of the POST on an Active Supervisor Engine, page 80-13
• Sample Display of the POST on a Standby Supervisor Engine, page 80-16
Sample Display of the POST on an Active Supervisor Engine
Examples include:
• Supervisor Engine 7-E, Supervisor Engine 7L-E, and Supervisor Engine 8-E, page 80-13
• Supervisor Engine 6-E and Supervisor Engine 6L-E, page 80-15
Supervisor Engine 7-E, Supervisor Engine 7L-E, and Supervisor Engine 8-E
Switch# show diagnostic result module 3 detail
Current bootup diagnostic level: minimal
module 3: SerialNo : CAT1450L1QU
Overall Diagnostic Result for module 3 : PASS
Diagnostic level at card bootup: minimal
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
1) supervisor-bootup ---------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test testing type ------> n/a
Last test execution time ----> Jul 21 2011 20:16:56
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 20:16:56
Total failure count ---------> 0
Consecutive failure count ---> 0
Power-On-Self-Test Results for ACTIVE Supervisor
prod: WS-X45-SUP7-E part: 73-12064-08 serial: CAT1450L1QU
Power-on-self-test for Module 3: WS-X45-SUP7-E
Test Status: (. = Pass, F = Fail, U = Untested)
To Next Page
Loading...
