EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1449 background imageLoading...
Page #1449 background image
53-7
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 53 Configuring Wired Guest Access
Configuration Examples for Wired Guest Access
Wired-guest-access ports initially terminate on a Layer 2 access switch or switch port configured with
VLAN interfaces for wired-guest-access traffic. The wired guest traffic is then trunked from the access
switch to a controller. This controller is configured with an interface that is mapped to a
wired-guest-access VLAN on the access switch.
!
interface GigabitEthernet1/1
description Connected to Client_Laptop
switchport access vlan 10
switchport mode access
access-session host-mode single-host
access-session closed
access-session port-control auto
access-session control-direction in
mab
dot1x pae authenticator
dot1x timeout tx-period 5
service-policy type control subscriber Guest-Access
!
interface GigabitEthernet1/2
description Connected_to_MobilityController
switchport mode trunk
!
interface Vlan10
description CLIENT-VLAN
ip address 172.16.10.201 255.255.255.0
ip helper-address 172.16.10.200
!
interface Vlan80
description MANAGEMENT-VLAN
ip address 10.20.1.1 255.255.255.0
!
wireless management interface Vlan80
wireless mobility controller ip 10.20.1.2 public-ip 10.20.1.2 << Mobility Controller IP >>
!
guest-lan glan-1 1
shutdown
client vlan Vlan10
no security web-auth << Use "security webauth" for webauth access & "no security webauth"
for open access. >>
mobility anchor 10.20.1.3 << Guest Controller IP >>
no shutdown
!
Example: Configuring the Mobility Controller
The following example shows how to configure the interface ports and wireless mobility on the mobility
controller to enable wired guest access.
!
interface GigabitEthernet1/1
description Connected-to-MobilityAgent
switchport mode trunk
!
interface GigabitEthernet1/2
description Connected-to-GuestController
switchport mode trunk
!
interface Vlan80
description MANAGEMENT-VLAN
ip address 10.20.1.2 255.255.255.0

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals