CHAPTER
79-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
79
Configuring RMON
This chapter describes how to configure Remote Network Monitoring (RMON) on your Catalyst 4500
series switch. RMON is a standard monitoring specification that defines a set of statistics and functions
that can be exchanged between RMON-compliant console systems and network probes. RMON provides
you with comprehensive network-fault diagnosis, planning, and performance-tuning information.
This chapter consists of these sections:
• About RMON, page 79-1
• Configuring RMON, page 79-3
• Displaying RMON Status, page 79-6
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch.
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases.
About RMON
RMON is an Internet Engineering Task Force (IETF) standard monitoring specification that allows
various network agents and console systems to exchange network monitoring data. You can use the
RMON feature with the Simple Network Management Protocol (SNMP) agent in the switch to monitor
all the traffic flowing among switches on all connected LAN segments.
To Next Page
Loading...
