Cisco Catalyst 4500 Series Software Configuration Guide

72-10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 72 Configuring SNMP
Configuring SNMP
Step 3
Switch(config)# snmp-server group
groupname
{v1 | v2c | v3 [auth | noauth
|
priv]} [read readview] [write
writeview] [notify notifyview] [access
access-list]
Configures a new SNMP group on the remote device.
• For groupname, specify the name of the group.
• Specify a security model:
– v1 is the least secure of the possible security models.
– v2c is the second least secure model. It allows transmission
of informs and integers twice the normal width.
– v3, the most secure, requires you to select an authentication
level:
auth—Enables the Message Digest 5 (MD5) and the Secure
Hash Algorithm (SHA) packet authentication.
noauth—The noAuthNoPriv security level. it is the default if
no keyword is specified.
priv—Enables Data Encryption Standard (DES) packet
encryption (also called privacy).
Note The priv keyword is available only when the crypto software
image is installed.
• (Optional) Enter read readview with a string (not to exceed 64
characters) that is the name of the view in which you can only
view the contents of the agent.
• (Optional) Enter write writeview with a string (not to exceed 64
characters) that is the name of the view in which you enter data
and configure the contents of the agent.
• (Optional) Enter notify notifyview with a string (not to exceed 64
characters) that is the name of the view in which you specify a
notify, inform, or trap.
• (Optional) Enter access access-list with a string (not to exceed 64
characters) that is the name of the access list.
Command Purpose

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E