Cisco Catalyst 4500 Series - Page 1187

44-91
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 44 Configuring Quality of Service
Configuring Auto-QoS on a Standalone Supervisor Engine 6-E/6L-E or Supervisor Engine 7-E/7L-E/8-E
! Note: For COS, Control traffic only has a single COS value of 3 (versus DSCP which has 2
values to match). So, only 2 class-maps instead of 3 like above.
policy-map AutoQos-VoIP-Input-Cos-Policy
class AutoQos-VoIP-Bearer-Cos
set qos-group 46
class AutoQos-VoIP-Control-Cos
set qos-group 24
Policy Map AutoQos-4.0-Input-Policy
Class AutoQos-4.0-VoIP
set qos-group 32
Class AutoQos-4.0-Broadcast-Vid
set qos-group 32
Class AutoQos-4.0-Realtime-Interact
set qos-group 32
Class AutoQos-4.0-Network-Ctrl
set qos-group 16
Class AutoQos-4.0-Internetwork-Ctrl
set qos-group 16
Class AutoQos-4.0-Signaling
set qos-group 16
Class AutoQos-4.0-Network-Mgmt
set qos-group 16
Class AutoQos-4.0-Multimedia-Conf
set qos-group 34
Class AutoQos-4.0-Multimedia-Stream
set qos-group 26
Class AutoQos-4.0-Transaction-Data
set qos-group 18
Class AutoQos-4.0-Bulk-Data
set qos-group 10
Class AutoQos-4.0-Scavenger
set qos-group 8
Policy Map AutoQos-4.0-Cisco-Phone-Input-Policy
Class AutoQos-4.0-VoIP-Data-Cos
set dscp ef
set qos-group 32
police cir 128000 bc 8000
conform-action transmit
exceed-action set-dscp-transmit cs1
exceed-action set-cos-transmit 1
Class AutoQos-4.0-VoIP-Signal-Cos
set dscp cs3
set qos-group 16
police cir 32000 bc 8000
conform-action transmit
exceed-action set-dscp-transmit cs1
exceed-action set-cos-transmit 1
Class AutoQos-4.0-Default-Classify
set dscp default
set cos 0
police cir 10000000 bc 8000
conform-action transmit
exceed-action set-dscp-transmit cs1
exceed-action set-cos-transmit 1
Policy Map AutoQos-4.0-Cisco-Softphone-Input-Policy
Class AutoQos-4.0-VoIP-Data
set dscp ef
set cos 5
set qos-group 32