EasyManuals Logo

Cisco Catalyst 4500 Series Software Configuration Guide

Cisco Catalyst 4500 Series
2086 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1464 background imageLoading...
Page #1464 background image
55-2
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 55 Configuring Port Security
Port Security Commands
port-security mac-address Configures all secure MAC addresses
on each VLAN.
Secure MAC Addresses, page 55-3
port-security maximum Configures a maximum number of
MAC addresses on an interface.
Configuring Port Security on Access
Ports, page 55-7
private-vlan association add Creates an association between a
secondary VLAN and a primary
VLAN.
Example of Port Security on an
Isolated Private VLAN Host Port,
page 55-16
private-vlan isolated Designates the VLAN as a private
VLAN.
Configuring Port Security on an
Isolated Private VLAN Host Port,
page 55-14
private-vlan primary Specifies the VLAN as the primary
private VLAN.
Configuring Port Security on an
Isolated Private VLAN Host Port,
page 55-14
switchport mode private-vlan host Specifies that ports with valid private
VLAN trunk association become
active host private VLAN trunk
ports.
Configuring Port Security on an
Isolated Private VLAN Host Port,
page 55-14
switchport private-vlan
host-association
Defines a host association on an
isolated host port.
Configuring Port Security on an
Isolated Private VLAN Host Port,
page 55-14
switchport private-vlan mapping Defines a private VLAN for the
promiscuous ports.
Configuring Port Security on an
Isolated Private VLAN Host Port,
page 55-14
switchport port-security Enables port security. Configuring Port Security on Access
Ports, page 55-7
switchport port-security aging static Configures static aging of MAC
address.
Aging Secure MAC Addresses,
page 55-5
switchport port-security aging time Specifies an aging time for a port. Example 3: Setting the Aging Timer,
page 55-11
switchport port-security limit rate
invalid-source-mac
Sets the rate limit for bad packets. Example 7: Setting a Rate Limit for
Bad Packets, page 55-13
switchport port-security mac-address Configures a secure MAC address for
an interface.
Example 5: Configuring a Secure
MAC Address, page 55-12
switchport port-security mac-address
mac_address sticky
Specifies the sticky MAC address for
an interface.
Configuring Port Security on Access
Ports, page 55-7
switchport port-security mac-address
sticky
Enables sticky Port Security. Sticky Addresses on a Port,
page 55-5
no switchport port-security
mac-address sticky
Converts a sticky secure MAC
address to a dynamic MAC secure
address.
Configuring Port Security on Access
Ports, page 55-7
switchport port-security maximum Sets the maximum number of secure
MAC addresses for an interface.
Example 1: Setting Maximum
Number of Secure Addresses,
page 55-11
switchport port-security violation Sets the violation mode. Example 2: Setting a Violation
Mode, page 55-11
Command Purpose Navigation

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals