Cisco Catalyst 4500 Series Software Configuration Guide

56-7
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 56 Configuring Auto Security
Guidelines and Restrictions
– Starting with Cisco IOS XE 3.6.0E (IOS 15.2.(2)E), all trunk ports are treated as uplink ports
and all access port are treated as host ports.
– AS assumes that you will configure the port with data and voice VLANs.
– AS is not supported on routed or Layer 3 ports, dynamic ports, or VSL links.
• Enabling auto security should elicit system confirmation because the current baseline security
configuration will be removed as the auto security configuration is applied. When auto security is
globally enabled, existing configurations related to DAI, DHCP, and PSEC are removed and security
violation may be triggered on the auto-security enabled port when incoming MACs exceed the limit.
When we issue auto security in global or interface config mode, any baseline security configuration
on the interfaces or on the switch is removed and auto security configuration is applied. Disabling
auto security does not restore the previous security configuration.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E