72-12
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 72 Configuring SNMP
Configuring SNMP
config
Generates a trap for SNMP configuration changes.
config-copy
Generates a trap for SNMP copy configuration changes.
cpu
Allows cpu-related traps.
eigrp
Enable EIGRP traps.
Note This option is only available when the enhanced multilayer image is
installed.
entity
Generates a trap for SNMP entity changes.
envmon
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, supply, temperature.
flash
Generates SNMP FLASH notifications.
fru-ctrl
Enable SNMP entity FRU control traps.
hsrp
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
ipmulticast
Generates a trap for IP multicast routing changes.
isis
Enable IS-IS traps.
Note This option is only available when the enhanced multilayer image is
installed.
mac-notification
Generates a trap for MAC address notifications.
msdp
Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
Note This option is only available when the enhanced multilayer image is
installed.
ospf
Generates a trap for Open Shortest Path First (OSPF) changes. You can enable
any or all of these traps: Cisco specific, errors, link-state advertisement, rate
limit, retransmit, and state changes.
Note This option is only available when the enhanced multilayer image is
installed.
pim
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can
enable any or all of these traps: invalid PIM messages, neighbor changes, and
rendezvous point (RP)-mapping changes.
port-security
Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
rf
Enable all SNMP traps defined in Cisco-RF-MIB.
snmp
Generates a trap for SNMP-type notifications for authentication, cold start,
warm start, link up or link down.
storm-control
Generates a trap for SNMP storm-control. You can also set a maximum trap
rate per second. The range is from 0 to 1000; the default is 0 (no limit is
imposed; a trap is sent at every occurrence).
stpx
Generates SNMP STP Extended MIB traps.
syslog
Generates SNMP syslog traps.
Table 72-3 Switch Notification Types (continued)
Notification Type
Keyword Description
To Next Page
Loading...
