Cisco Catalyst 4500 Series Software Configuration Guide

74-7
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 74 Configuring Flexible NetFlow
VSS Environment
total length IPv6 total packet length Values are based on Table 74-2.
Total length
minimum
Minimum packet size
seen
Total length
maximum
Maximum packet size
seen
protocol IPv6 next header type in
the last IPv6 extension
header
source address IPv6 source address
traffic-class IPv6 traffic class Yes
Routing Attributes
forwarding-status Forwarding status for the
packet (forwarded,
terminated in the router,
dropped by ACL, RPF,
CAR)
Supported as a non-key field
Layer 4 Header Fields
Field Description Comments
TCP Header Fields
destination-port
TCP destination
number
TCP destination port
flags [ack] [fin]
[psh] [rst] [syn]
[urg]
TCP flags. Supported as non-key fields.
source-port TCP source port
UDP Header Fields
destination-port UDP destination port
source-port UDP source port
ICMP Header Fields
code ICMP code
type ICMP type
IGMP Header Fields
type IGMP
Interface Fields
input Input interface index
output Input interface index Output interface can be supported
only as non-key.
Flexible NetFlow feature related fields
direction: input
Table 74-3 Options Available through FNF and the Supported Fields
Field Description Comments

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E