Cisco Catalyst 4500 Series - Page 1849

74-13
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 74 Configuring Flexible NetFlow
Non-VSS Environment
IPv6 Fields
destination address IPv6 destination address
dscp IPv6 DSCP (part of IPv6
traffic class)
flow-label IPv6 flow label
is-multicast Indicator of an IPv6
multicast packet (0 - if
it's not, 1 - if it is)
Supported as a
non-key field
hop-limit IPv6 hop limit (replaces
IPv4 ttl)
Values are reported
based on Table 74-4.
hop-limit minimum IPv6 minimum hop limit
value seen in the flow.
Supported as a
non-key field.
hop-limit maximum IPv6 maximum hop limit
value seen in the flow.
Supported as a
non-key field.
next-header IPv6 next header type Only first next header
is reported
total length IPv6 total packet length Values are based on
Table 74-5.
Total length
minimum
Minimum packet size
seen
Total length
maximum
Maximum packet size
seen
protocol IPv6 next header type in
the last IPv6 extension
header
source address IPv6 source address
traffic-class IPv6 traffic class Yes
Routing Attributes
forwarding-status Forwarding status for the
packet (forwarded,
terminated in the router,
dropped by ACL, RPF,
CAR)
Supported as a
non-key field
Layer 4 Header Fields
Field Description Comments
TCP Header Fields
destination-port
TCP destination
number
TCP destination port
flags [ack] [fin]
[psh] [rst] [syn]
[urg]
TCP flags. Supported as non-key
fields.
Table 74-6 Options Available through FNF and the Supported Fields
Field Description Comments