Cisco Catalyst 4500 Series - Page 2053

Index
IN-13
Software Configuration Guide—Release IOS XE 3.9.0E and IOS 15.2(5)E
messages 34
protocol
defined
33
monitoring 49
remote failure indications 34
remote loopback 34, 37
templates 45
Ethernet OAM protocol CFM notifications 51
Ethernet Remote Defect Indication (ETH-RDI) 28
event triggers, user-defined
configuring, 802.1X-based
8
configuring, MAC address-based 9
explicit host tracking
enabling
11
extended range VLANs
See VLANs
Extensible Authentication Protocol over LAN
1
Exterior Gateway Protocol
See EGP
F
Fa0 port
See Ethernet management port
Failure detection, using BFD
7
Fallback Authentication
configure with 802.1X
77
fast link notification
on VSL failure
13
Fast UDLD
configuring probe message interval
8
default configuration 3
displaying link status 9
enabling globally 5
enabling on individual interface 7
enabling per-interface 6
modes of operation 3
resetting disabled LAN interfaces 8
use case 2
Fast UDLD, overview 1
FastDrop
overview
11
fastethernet0 port
See Ethernet management port
Fast-Hello
dual-active detection
24
Fast-Hello dual-active detection, configuring 53
feature interactions, Wireshark 10
FIB
description
2
See also MFIB
fiber-optics interfaces
disabling UDLD
7
Filter-ID ACL and Per-User ACL, configureport-based
authentication
configure Per-User ACL and Filter-ID ACL
45
filtering
in a VLAN
21
non-IP traffic 16, 17
filters, Wireshark 6
flags 12
Flash memory
configuring router to boot from
32
loading system images from 31
security precautions 32
Flex Links
configuration guidelines
5
configuring 6
configuring preferred VLAN 9
configuring VLAN load balancing 8
monitoring 12
Flexible NetFlow
caveats
8
defined 4, 1
flooded traffic, blocking 2
flow control, configuring 32
flowchart, traffic marking procedure 21, 55