Cisco Catalyst 4500 Series - Page 281

5-55
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 5 Configuring Virtual Switching Systems
Configuring a VSS
Received id: e8b7.488e.b7c0
Expected id: e8b7.488e.b700
This example shows how to display the summary status for dual-active detection when recovery is
triggered by RRP rather than PagP:
Switch# show switch virtual dual-active summary
Switch(recovery-mode)# show switch virtual dual-act summary
Pagp dual-active detection enabled: Yes
In dual-active recovery mode: Yes
Triggered by: RRP
This example shows how to display PAgP status and the channel groups with trust mode enabled:
Switch# show pagp dual-active
PAgP dual-active detection enabled: Yes
PAgP dual-active version: 1.1
Channel group 25 dual-active detect capability w/nbrs
Dual-Active trusted group: Yes
Dual-Active Partner Partner Partner
Port Detect Capable Name Port Version
Gi1/3/11 Yes g9-68 Gi1/11 1.1
Gi2/2/12 Yes g9-68 Gi1/12 1.1
This example shows how to display the status of links configured as fast-hello:
Switch# show switch virtual dual-active fast-hello
Executing the command on VSS member switch role = VSS Active, id = 2
Fast-hello dual-active detection enabled: Yes
Fast-hello dual-active interfaces:
Port Local State Peer Port
---------------------------------------------------
Gi2/2/11 Dual Active Capable Gi1/1/5
Executing the command on VSS member switch role = VSS Standby, id = 1
Fast-hello dual-active detection enabled: Yes
Fast-hello dual-active interfaces:
Port Local State Peer Port
---------------------------------------------------
Gi1/1/5 Dual Active Capable Gi2/2/11
This example shows how to display the status of packet exchanges between the individual fast-hello
links:
Switch# show switch virtual dual-active fast-hello counters
Executing the command on VSS member switch role = VSS Active, id = 2
Dual-active fast-hello link counters:
Tx Rx
Port OK OK
--------------------------------------
Gi2/2/11 762 759
Executing the command on VSS member switch role = VSS Standby, id = 1