Cisco Catalyst 4500 Series Software Configuration Guide

6-18
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 6 Programmability
Using ODM Models
<cisco-ia xmlns="http://cisco.com/yang/cisco-ia">
<odm-control>true</odm-control>
</cisco-ia>
</data>
</rpc-reply>
Example: Activating or Starting the ODM
In the example below, the RPC reply (ok) indicates that the ODM is activated successfully.
Input
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<running/>
</target>
<config xmlns:xc="urn:ietf:params:xml:ns:netconf:base:1.0">
<cisco-ia xmlns="http://cisco.com/yang/cisco-ia">
<odm-control>true</odm-control>
</cisco-ia>
</config>
</edit-config>
</rpc>
Output
NETCONF RETURN
--------------
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="101">
<ok/>
</rpc-reply>
To deactivate or stop the ODM, send the following RPC:
Input
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<running/>
</target>
<config xmlns:xc="urn:ietf:params:xml:ns:netconf:base:1.0">
<cisco-ia xmlns="http://cisco.com/yang/cisco-ia">
<odm-control>false</odm-control>
</cisco-ia>
</config>
</edit-config>
</rpc>
Output
NETCONF RETURN
--------------
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="101">
<ok/>
</rpc-reply>

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E