Cisco Catalyst 4500 Series - Page 869

29-11
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 29 Configuring IPv6 Multicast Listener Discovery Snooping
Displaying MLD Snooping Information
Table 29-2 Commands for Displaying MLD Snooping Information
Command Purpose
show ipv6 mld snooping [vlan vlan-id]
Displays the MLD snooping configuration information for all VLANs
on the switch or for a specified VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
show ipv6 mld snooping mrouter [vlan
vlan-id]
Displays information on dynamically learned and manually configured
multicast router interfaces. When you enable MLD snooping, the switch
automatically learns the interface to which a multicast router is
connected. These are dynamically learned interfaces.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
show ipv6 mld snooping querier [vlan
vlan-id]
Displays information about the IPv6 address and incoming port for the
most-recently received MLD query messages in the VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.