Contents
16
Software Configuration Guide—Release IOS XE 3.9.xE and IOS 15.2(5)Ex
About Cisco IOS NSF-Aware and NSF-Capable Support 13-2
NSF with SSO Supervisor Engine Redundancy Overview 13-3
SSO Operation 13-4
NSF Operation 13-4
Cisco Express Forwarding 13-5
Routing Protocols 13-5
BGP Operation 13-5
OSPF Operation 13-6
IS-IS Operation 13-7
EIGRP Operation 13-8
NSF Guidelines and Restrictions 13-9
Configuring NSF with SSO Supervisor Engine Redundancy 13-9
Configuring SSO 13-10
Configuring CEF NSF 13-11
Verifying CEF NSF 13-11
Configuring BGP NSF 13-11
Verifying BGP NSF 13-12
Configuring OSPF NSF 13-13
Verifying OSPF NSF 13-13
Configuring IS-IS NSF 13-14
Verifying IS-IS NSF 13-15
Configuring EIGRP NSF 13-16
Verifying EIGRP NSF 13-16
Cisco High Availability Features in Cisco IOS XE 3.1.0SG 13-17
Environmental Monitoring and Power Management 14-1
About Environmental Monitoring 14-1
Using CLI Commands to Monitor your Environment 14-2
Displaying Environment Conditions 14-2
Displaying On Board Failure Logging (OBFL) information for 9000W AC 14-4
Emergency Actions 14-5
System Alarms 14-6
Power Management 14-7
Power Management for the Catalyst 4500 series switches 14-7
Supported Power Supplies 14-8
Power Management Modes for the Catalyst 4500 Switch 14-9
Selecting a Power Management Mode 14-10
Power Management Limitations in Catalyst 4500 series switches 14-10
Available Power for Catalyst 4500 Series Switches Power Supplies 14-14
Special Considerations for the 4200 W AC and 6000 W AC Power Supplies 14-15
To Next Page
Loading...
