Contents
17
Software Configuration Guide—Release IOS XE 3.9.xE and IOS 15.2(5)Ex
Combined Mode Power Resiliency 14-19
Special Considerations for the 1400 W DC Power Supply 14-21
Special Considerations for the 1400 W DC SP Triple Input Power Supply 14-22
Powering Down a Module 14-22
Power Management for the Catalyst 4948 Switches 14-23
Power Management Modes for the Catalyst 4948 Switch 14-23
IEEE 802.3az Energy Efficient Ethernet 14-23
Determining EEE Capability 14-24
Enabling EEE 14-24
Determining EEE Status 14-24
Configuring Power over Ethernet 15-1
About Power over Ethernet 15-1
Hardware Requirements 15-2
Power Management Modes 15-2
Intelligent Power Management 15-4
Configuring Power Consumption for Powered Devices on an Interface 15-5
Displaying the Operational Status for an Interface 15-6
Displaying all PoE Detection and Removal Events 15-7
Displaying the PoE Consumed by a Module 15-8
PoE Policing and Monitoring 15-12
PoE Policing Modes 15-12
Configuring Power Policing on an Interface 15-13
Displaying Power Policing on an Interface 15-14
Configuring Errdisable Recovery 15-14
Enhanced Power PoE Support on the E-Series Chassis 15-15
Configuring Universal PoE 15-16
Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant 16-1
About Network Assistant 16-2
Community Overview 16-2
Clustering Overview 16-2
Network Assistant-Related Parameters and Their Defaults 16-2
Network Assistant CLI Commands 16-3
Configuring Your Switch for Network Assistant 16-4
(Minimum) Required Configuration 16-4
(Additional) Configuration Required to Use Community 16-5
(Additional) Configuration Required to Use Clustering 16-5
Managing a Network Using Community 16-6
To Next Page
Loading...
