Cisco Catalyst 4500 Series - Page 2081

Index
IN-41
Software Configuration Guide—Release IOS XE 3.9.0E and IOS 15.2(5)E
configuring 9
(examples) ??–12
BOOTP 8
DHCP 8
enterprise network (figure) 6
prerequisites 9
routing table requirements 7
tasks 9
verifying 10
deploying 5
description 22, 1
disabling 11
enterprise network (figure) 6
FIB 2
implementing 4
packets, dropping (figure) 4
prerequisites 9
restrictions
basic
8
routing asymmetry 7
routing asymmetry (figure) 8
routing table requirements 7
security policy
applying
5
attacks, mitigating 5
deploying 5
tunneling 5
source addresses, validating 3
(figure) 3, 4
failure 3
traffic filtering 5
tunneling 5
validation
failure
3, 4
packets, dropping 3
source addresses 3
verifying 10
unicast traffic
blocking
2
Unidirectional Controlled Port, configuring 802.1X 66
unidirectional ethernet
enabling
2
example of setting 2
overview 1
UniDirectional Link Detection Protocol
See UDLD
Universal PoE, configuring
16
UNIX syslog servers
daemon configuration
10
facilities supported 12
message logging configuration 11
uplink forwarding
quad-supervisor
6
uplink mode, selecting on supervisor engine 6-E 20
uplink port, selecting on a supervisor engine 7L-E 25
UplinkFast
and MST
23
enabling 23
MST and 23
overview 19
usage examples, Wireshark 18
user EXEC mode 5
user sessions
disconnecting
7
monitoring 6
user-defined event triggers
configuring, 802.1X-based
8
configuring, MAC address-based 9
User-defined triggers and built-in macros, configuring
mapping
9
V
VACLs
Layer 4 port operations
10
virtual configuration register 3
virtual LANs
See VLANs