Cisco Catalyst 4500 Series Software Configuration Guide

5-50
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 5 Configuring Virtual Switching Systems
Configuring a VSS
Switch(config-if)# no ip address
Switch(config-if)# channel-group 1 mode desirable
Switch(config-if)# end
Note See the “Configuring a Range of Interfaces” section on page 9-4 for information about the range
keyword.
The following two examples show how to verify the configuration of GigabitEthernet interface 1/3/26:
Switch# show running-config interface gigabitEthernet 1/3/26
Building configuration...
Current configuration : 101 bytes
!
interface GigabitEthernet1/3/26
no switchport
no ip address
channel-group 1 mode desirable
end
Switch# show interfaces gigabitEthernet 1/3/26 etherchannel
Port state = Up Mstr In-Bndl
Channel group = 1 Mode = Desirable-Sl Gcchange = 0
Port-channel = Po1 GC = 0x00010001 Pseudo port-channel = Po1
Port index = 0 Load = 0x00 Protocol = PAgP
Flags: S - Device is sending Slow hello. C - Device is in Consistent state.
A - Device is in Auto mode. P - Device learns on physical port.
d - PAgP is down.
Timers: H - Hello timer is running. Q - Quit timer is running.
S - Switching timer is running. I - Interface timer is running.
Local information:
Hello Partner PAgP Learning Group
Port Flags State Timers Interval Count Priority Method Ifindex
Gi1/3/26 SC U6/S7 H 30s 1 128 Any 632
Partner's information:
Partner Partner Partner Partner Group
Port Name Device ID Port Age Flags Cap.
Gi1/3/26 3750x 2c54.2dd4.ad80 Gi1/0/25 20s SAC 50001
Age of the port in the current state: 0d:00h:04m:04s
Switch#
This example shows how to verify the configuration of port channel interface 1 after the interfaces have
been configured:
Switch# show etherchannel 1 port-channel
Port-channels in the group:
---------------------------
Port-channel: Po1
------------
Age of the Port-channel = 0d:00h:53m:41s
Logical slot/port = 21/1 Number of ports = 2
GC = 0x00010001
Passive port list = Gi1/3/26 Gi2/2/26
Port state = Port-channel L3-Ag Ag-Inuse
Protocol = PAgP

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E