Contents
34
Software Configuration Guide—Release IOS XE 3.9.xE and IOS 15.2(5)Ex
Enabling IPv4 PBR 42-7
Enabling IPv6 PBR 42-10
Enabling Local IPv4 and Local IPv6 PBR 42-12
IPv4 42-12
IPv6 42-12
Configuring IPv4 and IPv6 PBR for VRF Instances 42-12
Verifying the PBR Configuration for VRF Instances 42-14
Verifying Next-Hop IP using Object Tracking 42-14
Unsupported Commands 42-15
Policy-Based Routing Configuration Examples 42-16
Equal Access 42-16
Differing Next Hops 42-17
Deny ACE 42-17
Examples of the show Command 42-17
Configuring VRF-lite 43-1
About VRF-lite 43-2
VRF-lite Configuration Guidelines 43-3
Configuring VRF-lite for IPv4 43-4
Configuring VRFs 43-4
Configuring VRF-Aware Services 43-5
Configuring the User Interface for ARP 43-6
Configuring Per-VRF for TACACS+ Servers 43-6
Configuring Multicast VRFs 43-7
Configuring a VPN Routing Session 43-8
Configuring BGP PE to CE Routing Sessions 43-9
VRF-lite Configuration Example 43-10
Configuring Switch S8 43-10
Configuring Switch S20 43-12
Configuring Switch S11 43-12
Configuring the PE Switch S3 43-13
Displaying VRF-lite Status 43-14
Configuring VRF-lite for IPv6 43-14
Configuring VRF-Aware Services 43-14
Configuring the User Interface for ARP 43-15
Configuring the User Interface for PING 43-15
Configuring the User Interface for uRPF 43-15
Configuring the User Interface for Traceroute 43-16
Configuring the User Interface for FTP and TFTP 43-16
Configuring the User Interface for Telnet and SSH 43-17
To Next Page
Loading...
