Cisco Catalyst 4500 Series - Page 2072

Index
IN-32
Software Configuration Guide—Release IOS XE 3.9.0E and IOS 15.2(5)E
synchronization 4, 5
redundancy (SSO)
redundancy command
10
route processor redundancy 3
synchronization 5
reload command 29
Remote Authentication Dial-In User Service
See RADIUS
remote failure indications
34
remote loopback, Ethernet OAM 34, 37
Remote Network Monitoring
See RMON
rendezvous point, configuring
17
rendezvous point, configuring single static 21
REP
administrative VLAN
8
administrative VLAN, configuring 9
and STP 6
configuration guidelines 7
configuring interfaces 10
convergence 4
default configuration 7
manual preemption, configuring 13
monitoring 14
neighbor offset numbers 5
open segment 2
ports 6
preempt delay time 5
primary edge port 4
ring segment 2
secondary edge port 4
segments 1
characteristics 2
SNMP traps, configuring 14
supported interfaces 1
triggering VLAN load balancing 6
verifying link integrity 4
VLAN blocking 13
VLAN load balancing 4
replication
description
9
report suppression, IGMP
disabling
10
reserved-range VLANs
See VLANs
reset command
3
resetting a switch to defaults 34
resetting an interface to default configuration 48
Resilient Ethernet ProtocolLSee REP
responder, IP SLAs
described
4
enabling 7
response time, measuring with IP SLAs 4
restricting access
NTP services
8
RADIUS 95
TACACS+ 15
Restrictions and Guidelines for Configuring AVC with
DNS-AS
6
retransmission number
setting in 802.1X authentication
86
retransmission time
changing in 802.1X authentication
85
RFC
1157, SNMPv1
2
1305, NTP 2
1757, RMON 2
1901, SNMPv2C 2
1902 to 1907, SNMPv2 2
2273-2275, SNMPv3 2
RFC 5176 Compliance 98
RIP
description
19
for IPv6 6
RIP, introduction 19
RMON
default configuration
3
displaying status 6