3. SPECIFICATIONS
20
Ethernet Port
Supported Standard IEEE802.3
Supported Protocol
TELNET (*4) Command control, status query
FTP File transfer
SNMP Command control, alarm query
HTTP Remote monitoring and control from a Web browser
SNTP Internal clock synchronization
Connector Type RJ-45
Function Remote control from an external PC or remote controller
(*4), file transfer, status information query
Type 10Base-T, 100Base-TX, 1000Base-T
Remote Connector
Port Type 15-pin D-sub (female)
Locking Screws Inch screws (No.4-40UNC)
Number of Ports 1
Control Signal LV-TTL level (low active)
Input Voltage Range 0 to 5 V DC
All inputs are pulled up to +3.3 V (control is also possible
using +5 V)
Function Load preset settings, switch input signals, transmit alarm
signals, and activate tally
Alarm Output Outputs alarms signals when a format alarm occurs, when
various errors occur, when the fan malfunctions, or when the
internal temperature is abnormal
*1 We do not guarantee the operation of all USB-HDDs and USB memory. The this instrument may
not operate normally depending on the connected USB device.
*2 Pinch out and swipe operations are not supported.
*3 LEADER does not guarantee that all touch panel type monitors will work with the LV7300.
*4 You cannot use TELNET and the LV7290 at the same time.
3.3.9 Front Panel
Display (LV5300/LV5300A/LV5350)
LCD Type 7-inch color TFT
Resolution 1920×1080
Refresh Rate 60 Hz, 59.94 Hz, 50 Hz (free run)
Touch Panel Electrostatic touch panel
Tapping the display shows touch keys
Key LEDs All the keys are dimly back-lit.
The selected key is lit more brightly.
Power Switch Electronic switch (which remembers whether the instrument
is on or off)
Last Memory Backs up the panel settings to memory
Key Lock Lock by holding down the SYS key. Prevents unintentional
operations on the instrument.
To Next Page
Loading...
