Leader LV5300A - How to Enter Commands; FTP Commands

19. Network Control
460
6. Enter FTP commands.
Enter commands while referring to sections 19.3.2, “How to Enter Commands,” and
19.3.3, “FTP Commands.” You must generate files using the TELNET "MAKE" command
before you use FTP commands.
To end an FTP session, type “bye” in lowercase letters.
ftp> bye
19.3.2 How to Enter Commands
The command syntax is explained below.
ftp> [Command] + [Space] + [Parameter 1] + [Space] + [Parameter 2]
Examples of how to enter commands are shown below.
ftp> get log.txt D:\log.txt ................... Transfer the event log file to the PC.
200 PORT Command successful ............ Return value
…
ftp>
19.3.3 FTP Commands
Table 19-2 FTP commands
Command
Parameter 1
Parameter 2
get
log.txt
Storage location on the PC and file name (example: D:\log.txt)
dump.txt
Storage location on the PC and file name (example: D:\dump.txt)
cap_bmp.bmp
Storage location on the PC and file name (example: D:\capture.bmp)
cap_bsg.bsg
Storage location on the PC and file name (example: D:\capture.bsg)
lv5300.my
Storage location on the PC and file name (example: D:\lv5300.my)