Leader LV5300A - How to Enter Commands

19. Network Control
440
5. Type the login name and password.
The login name and password are “LV5300”. Use uppercase for all characters.
When the login name and password are entered correctly, “LV5300@LV5300:~$”
appears.
LV5300 login: LV5300
Password: ******
LV5300@LV5300:~$
6. Enter TELNET commands.
Enter commands by referring to sections 19.2.2, “How to Enter Commands,” and
19.2.3, “TELNET Commands.”
To end a TELNET session, type “exit” in lowercase letters.
LV5300@LV5300:~$ exit
19.2.2 How to Enter Commands
The command syntax is explained below. (Some commands do not have parameters.)
To query a current setting, use a question mark as the parameter.
LV5300@LV5300:~$ [Command] + [Space] + [Parameter]
Examples of how to enter commands are shown below.
• Showing the Status Display
LV5300@LV5300:~$ STATUS
• Displaying the Center Marker in the Picture Display
LV5300@LV5300:~$ PIC:MARKER:CENTER ON
• Querying the Vector Intensity
LV5300@LV5300:~$ VECTOR:INTEN ?
* You can enter commands using uppercase or lowercase letters.
* Because the display channel selection command is different depending on the display mode
(single or simul) and SDI signal input settings, check the INPUT KEY command.
* To query the measured value or detected value, you must use the INPUT KEY command to show
the measurement screen of the appropriate channel.
Further, for 4K 3G Dual Link settings, you must also select the link according to the link selection
command of each measurement item.