Leader LV5300A - Video Signal Waveform Display

3. SPECIFICATIONS
26
Enhanced Layout (SER26)
Function When multiple channels of single link are displayed, the
selected channel is automatically shown in a specific area.
You can make the specific area larger than the other areas to
show the selected channel enlarged.
Time Display
Displayed Contents Current time, time code
Current Time Display The time based on the internal clock
Time Code Display LTC, VITC, D-VITC (SD only)
Supported Standard
LTC, VITC SMPTE ST 12-2
D-VITC SMPTE ST 266
Tally Display
Remote Connector Turn on and off the tally display by controlling through the
remote connector
Camera ID Display
Instrument Setting Shows the camera ID set with the instrument’s menu
Iris Display Shows the Iris set with the instrument’s menu
3.3.14 Video Signal Waveform Display
Waveform Control
Display Mode
Overlay Overlays component signals
Parade Displays component signals side by side
Blanking Interval H and V blanking periods can be masked.
RGB Conversion Converts a YC
B
C
R
signal into an RGB signal and displays the
result
Channel Assignment GBR or RGB order
Pseudo-Composite Display Artificially converts component signals into composite signals
and displays the result
Line Select Displays the selected line
Sweep Modes H, V
Color 7 colors to choose from
Vertical Axis
Gain ×1, ×5, ×10
Variable Gain
Gain x1 ×0.2 to ×2.0
Gain x5 ×1.0 to ×10.0
Gain x10 ×2.0 to ×10.0
Amplitude Accuracy ±0.5% (single default display)
3G (1080/60P, 1080/59.94P, 1080/50P)
Y Signal ±0.5 % (1 to 60 MHz)
C
B
C
R
Signal ±0.5 % (0.5 to 30 MHz)
Low-Pass Attenuation ≥ 20 dB (at 40 MHz)