16. Status Display
389
• Starting the Event Log
When F•1 DISPLAY is set to TEXT or SPLICE, you can start the event log, follow the
procedure below.
Procedure
STATUS → F•4 ANC PACKET → F•1 PACKET ANALYSIS → F•4 V-ANC → F•3 SCTE /
CAMERA META → F•1 SCTE-104 → F•3 LOG: START / STOP
Settings
START: The event log is started. "NOW LOGGING" appears in the upper right of
the event log.
STOP: The event log is stopped. "LOGGING STOPPED" appears in the upper
right of the event log.
• Clearing the Event Log
When F•1 DISPLAY is set to TEXT or SPLICE, you can clear the event log, follow the
procedure below.
Procedure
STATUS → F•4 ANC PACKET → F•1 PACKET ANALYSIS → F•4 V-ANC → F•3 SCTE /
CAMERA META → F•1 SCTE-104 → F•4 CLEAR
• Selecting the Dump Mode
When F•1 DISPLAY is set to DUMP, you can use F•2 DUMP MODE to set the dump mode
to HEX (hexadecimal display) or BINARY (binary display).
To Next Page
Loading...
